Universal Adaptable Catalytic Converter | EURO IV Emission Standards | Round with Heat Protection | Total Length 340mm

Product Description:

Universal Adaptable Catalytic Converter | Suitable for EURO IV Emission Regulations (up to January 2005) and 2.0 cc maximum displacement | Round with Heat Protection | Total Length 340mm | With or Without Lambda Sensor Hole | With screw for sensor annulment | With screw for sensor annulment | With or Without Lambda Sensor Hole | With or Without Lambda Sensor Hole | With screw for sensor annulment

Pipe Diameter (Inside x Outside): 42x45 | 47x50 | 51x54 | 54x57 | 61x64 | 76x80 mm | Select from Drop Down Menu

With | Without hole for Oxygen Sensor | Oxygen Sensor | Choose in Pull-Down Menu

Total Catalytic Converter Length (with extension pipe): 340mm

Catalytic converter length (without extension pipe): 230mm

Total width: up to 130mm

Part no:

KAT

Similar OEM part number:

Fitting Part : No OEM part number : Universal

Mounting Side:

Depending on Model

Compatible Models:

EURO IV Emission Standard (up to January 2005)

Other Specifications:

Material: Stainless Steel Sus409-1.2

Pipe Diameter (Inside x Outside): 42x45 | 47x50 | 51x54 | 54x57 | 61x64 | 76x80 mm | Choose from Drop Down Menu

With | Without hole for Oxygen Sensor | Oxygen Sensor | Choose in Pull-Down Menu

Catalytic converters with lambda sensor thread are supplied with a screw to cancel the hole if necessary.

Total Catalytic Converter Length (with extension pipe): 340mm

Catalytic converter length (without extension pipe): 230mm

Overall width: up to 130mm

Main causes of catalytic converter failure:

Engine tuning: incorrect air/fuel mixture, worn spark plugs, etc.

Unburnt fuel in the catalytic converter: misfiring, inadequate regulation of the intake mixture, etc., can lead to clogging of the ceramic monolith and even melting of the monolith.

Excessive oil consumption: clogging of the monolith, causing an excess of particles in the engine.

Knocks on the catalytic converter: breakage of the ceramic monolith.

What to do to correct these faults:

Ensure correct fitting and sealing of the catalytic converter and air cleaner and its constituent parts.

Check the cause of the fault in the original catalytic converter to be replaced and correct it.

Check the lambda sensor and, if necessary, replace it with a new one.

Tune up the engine (correct tuning)

Replace damaged or worn spark plugs.

The average life of a catalytic converter is approximately 80,000 Km, before installing a new catalytic converter, FIX THE PROBLEM THAT CAUSED THE INITIAL CATALYST FAILURE, if your vehicle has caused a failure in the emission of gases, the simple fact of replacing the catalytic converter without checking other possible failures could cause the failure in the new catalytic converter or an incorrect gas reading.

Warranty:

Item requires handling for installation and is therefore exempt from manufacturer's warranty.

This product is not homologated as it is an adaptation part.


The images of our products may vary according to the manufacturer, maintaining all the technical characteristics and compatibilities indicated in the product specifications.