Hyundai I20 Airbag Spiral Ring from 2008 to 2014 | OEM Similar to 93490-1J500 | 934901J500

Product Description:

Hyundai I20 Airbag Spiral Ring from 2008 to 2014 | OEM Similar to 93490-1J500 | 934901J500

Part Number:

T35629

OEM Similar Part Number:

93490-1J500 | 934901J500

Mounting Position:

Steering Wheel

Compatible Models:

HYUNDAI

I20 de 2008 | 2009 | 2010 | 2011 | 2012 | 2013 | 2014

Other Specifications:

Connections

1 2-Pin Airbag Connection (Steering Wheel) + 1 8-Pin Airbag Spiral Connection

2 Vehicle Installation Connections:

1 8-Pin Connection

1 4-Pin Connection + Terminal

Check compatibility with the original part number and attachments below.

THIS ELECTRICAL COMPONENT DOES NOT HAVE A WARRANTY OR RETURN POLICY.

ASSEMBLY INSTRUCTIONS

The airbag ring must be assembled and disassembled in the center position (the tires must be in the straight-ahead position) and the steering wheel must be completely centered.

The ring is supplied in the center position and is secured with a pin. The pin must be released after assembly, releasing the spring.

If re-centering is required, follow these instructions:

Turn the rotor counterclockwise (left) as far as it will go. Turn approximately 3.0 turns clockwise until the rotor marks align.

Under no circumstances should the spring be released before installation; otherwise, if released before assembly, the spring will be distorted beforehand, and it is very likely to come loose during the operation and become unusable.

Spiral Cable

The spiral cable connects the rigid steering column to the movable steering wheel. It ensures communication between the airbag control unit and the gas generator during the steering wheel's rotational motion. The conductive sheet is wound in such a way that it is capable of following the rotational motion of 2.5 turns in each direction.

It is important to be very careful when installing or removing this spiral cable. It must be ensured that the steering wheel is in the center position and that the wheels are also straight. If the spiral cable has been removed, it cannot be rewound.

The products supplied must be used only for their intended purpose. Assembly must be carried out by qualified personnel. The products are delivered without assembly instructions.